Camos Selfsat TOP Plus Bedienungsanleitung Seite 13

5. Connecting the Antenna
Connect the coaxial cable to the antenna and tighten. Feed the cable
sidewise through the lift assembly, then insert cable through gland in
rear of roof entry box and push cable into vehicle. Leave 70 cm of cable
(see indication) from antenna to roof entry. Following glue on the cable
entry box to the roof (e.g. with Sikaflex®).
Route cable to satellite receiver
and fit 'F' connector.
Connect to the connector marked
"SATELLITE IN" on the rear of the
satellite receiver.
6. To locate the satellite:
Using the zone map determine your location and note the angle of
elevation required. Turn the elevation handle counter clockwise (ccw) elevation required. Turn the elevation handle counter clockwise (ccw
the number of turns indicated in the graduation disc to get the elevation
for your location.
Note: The specifications are approximate values, depending on
the location.
Feed the cable
through gland in
Leave 70 cm of cable
Following glue on the cable
angle of
to get the elevation
depending on