Electrical Safety; Special Safety Instructions For Dust Collectors - HOLZMANN-MASCHINEN ABS850DBK Betriebsanleitung

 Before start-up, check the machine for completeness and function. Only use the machine if
the guards and other non-parting guards required for machining have been fitted, are in
good operating condition and have been properly maintained.
 Choose a level, vibration-free, non-slip surface for the installation location.
 Ensure sufficient space around the machine!
 Ensure sufficient lighting conditions at the workplace to avoid stroboscopic effects.
 Ensure a clean working environment.
 Only use perfect tools that are free of cracks and other defects (e.g. deformations).
 Remove tool keys and other adjustment tools before switching on the machine.
 Keep the area around the machine free of obstacles (e.g. dust, chips, cut parts, etc.).
 Check the strength of the machine connections before each use.
 Never leave the running machine unattended. Switch off the machine before leaving the
working area and secure it against unintentional or unauthorised recommissioning.
 The machine may only be operated, serviced or repaired by persons who are familiar with
it and who have been informed of the hazards arising from this work.
 Ensure that unauthorised persons maintain a safe distance from the machine and keep
children away from the machine.
 When working on the machine, never wear loose jewellery, loose clothing, ties or long,
open hair.
 Hide long hair under hair protection.
 Wear close-fitting protective clothing and suitable protective equipment (eye protection,
dust mask, ear protection; gloves only when handling tools).
 If there are connections for dust extraction, make sure that they are properly connected
and in working order.
 Always work with care and the necessary caution and never use excessive force.
 Do not overload the machine!
 Shut down the machine and disconnect it from the power supply before carrying out any
adjustment, conversion, cleaning, maintenance or repair work. Before starting any work
on the machine, wait until all tools or machine parts have come to a complete standstill
and secure the machine against unintentional restarting.
 Do not work on the machine if you are tired, not concentrated or under the influence of
medication, alcohol or drugs!
 Do not use the machine in areas where vapours from paints, solvents or flammable liquids
represent a potential danger (danger of fire or explosion!).

12.4 Electrical Safety

 Make sure that the machine is earthed.
 Only use suitable extension cords.
 A damaged or tangled cable increases the risk of electric shock. Handle the cable with care.
Never use the cable to carry, pull or disconnect the power tool. Keep the cable away from heat,
oil, sharp edges or moving parts.
 Proper plugs and sockets reduce the risk of electric shock.
 Water entry into machine increases the risk of electric shock. Do not expose machine to rain
or moisture.
 The machine may only be used in humid environments if the power source is protected by a
residual current circuit breaker.
 Do not use the power tool if it cannot be turned on and off with the ON-OFF-switch.

12.5 Special Safety Instructions for dust collectors

 Work only in well-ventilated rooms!
 Keep the unit away from potential ignition sources such as pilot lights and/or open flames
danger of fire and explosion!
 The suction of flammable or combustible vapours, liquids, dust, ash or chips (gases, fuel,
cleaning agents, paint residues, hydrogen, coal, magnesium, grain dust, stone dust, hot
ash, cigarette butts, etc.) is strictly prohibited.
 Do not insert any objects into the extraction opening and keep it free of deposits that
could impair the extraction performance.
 It is forbidden to remove the protective grille.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
SAFETY
21
ABS850DBK