Further Data; Operating Conditions - WIKA TG58SA Betriebsanleitung

9. Specifications
Accuracy specifications
Accuracy
1) The measuring range is indicated on the dial by two triangular marks. Only within this range is
the stated error limit valid per EN 13190.

Further data

Overtemperature resistance
Full-scale display value
≥ 50 °C [120 °F] ... ≤ 120 °C [250 °F]
Full-scale display value
> 120 °C [250 °F] ... ≤ 200 °C [400 °F]

Operating conditions

Ambient temperature range
(at the case)
Storage temperature range
Cleaning and sterilisation
(CIP and SIP)
1)
Max. operating pressure at stem
Ingress protection (IP code) per
IEC/EN 60529
2)
Insertion length l
1) The temperature must be below the overtemperature resistance of the instrument. The following
scale ranges must not be cleaned or sterilised with a max. of 150 °C [302 °F]: 0 ... 60 °C,
-50 ... +50 °C, 0 ... 140 °F, -40 ... +120 °F.
2) → See marking at the process connection in chapter 3.7 "Labelling, safety marks"
→ For further specifications, see WIKA data sheet TM 58.01 and the
order documentation.
WIKA operating instructions model TG58SA
1)
1
Class 1 per EN 13190
■
Grade A per ASME B40.200
■
+ 100 % overload safety in relation to
the full-scale display value
+ 50 % overload safety in relation to
the full-scale display value
-20 ... +60 °C [-4 ... +140 °F]
-50 ... +70 °C [-60 ... +160 °F]
150 °C [302 °F] continuously for
wetted parts
Max. 25 bar [362.59 psi], static
IP66
■
IP67
■
NEMA 4X/6
■
30 ... 300 mm [1.18 ... 11.81 in]
Minimum insertion length is
dependent upon scale range,
connection location and diameter
EN
21