After Finishing Work; Transporting - Stihl RE 100.0 PLUS CONTROL Gebrauchsanleitung

English
► Remove the detergent bottle (3).
► Unscrew cover (2).
► Dose and use detergent as described in the
instructions for use of the detergent.
► Screw the cover onto the detergent bottle (3)
and tighten it by hand.
► Insert the detergent bottle (3) into the holder
(1) on the pressure washer.
► Rotate 3-in-1 nozzle into position
the highest power level.

11 After Finishing Work

11.1 When Work is Finished
► Switch off the high-pressure washer and pull
the mains plug out of the socket.
► If the high-pressure washer is connected to
the water supply: Turn off water supply.
► Press the spray gun trigger.
The water pressure is reduced.
► Lock the spray gun trigger.
► Disconnect the high-pressure washer from the
water source.
► Remove the water hose.
► Remove and clean the nozzle and spray
lance.
► Remove the spray gun and let the rest of the
water run out of the spray gun.
► Clean the high-pressure washer.
1
6
5
► Wind up the high-pressure hose (1) evenly
distributed over the reel.
► Coil the connecting cable (2) on the holder (3).
► Secure the connecting cable (2) using the clip
(4).
► Insert the detergent bottle (5).
► Insert nozzle (6).
40
1
2
3
and set
2
3
4
7
7
7
► Store the spray attachment in the holders (7)
on the high-pressure washer.
11.2 Protecting the pressure washer
with antifreeze
If the pressure washer cannot be protected from
frost during transport or storage, the pressure
washer should be protected by a glycol-based
antifreeze. The antifreeze prevents water inside
the pressure washer from freezing and causing
damage to the pressure washer.
► Remove spray lance
► Connect the shortest possible water hose to
the pressure washer.
The shorter the water hose, the less antifreeze
is needed.
► Mix the antifreeze as described in the anti‐
freeze Instruction Manual.
► Pour antifreeze into a clean container.
► Insert water hose into container of antifreeze.
► Squeeze and hold spray gun trigger.
► Switch on pressure washer.
► Hold down spray gun trigger until an even jet
of antifreeze is delivered from the spray gun
and point the spray gun into the container.
► Press and release spray gun trigger several
times.
► Switch off pressure washer and unplug mains
plug from the socket.
► Detach spray gun and water hose and allow
antifreeze to run into the container.
► Store and dispose of antifreeze in accordance
with the applicable regulations and in an envi‐
ronmentally responsible manner.

12 Transporting

12.1 Transporting the high-pressure
washer
► Switch off the high-pressure washer and pull
the mains plug out of the socket.
► Empty or secure the detergent container so
that it cannot topple over, fall down and cannot
move.
11 After Finishing Work
7
7
0458-004-9621-B