Balluff BIS C-6 0 RS 232 Serie Handbuch Seite 46

C-6_0-007-00_836905_E_0704.p65
13
Menu settings
BIS C-6_0
Menu settings
BIS C-6_0,
Protocol Type Field
14
Menu settings
BIS C-6_0,
Protocol Type Field
(continued)
Menu settings
BIS C-6_0,
Parameter Field
14 english
BIS C-6_0
Configuration
PARAMETERS BIS C-600
Parameters
[ ] CT-Present on RTS line
[ ] Direct data transmission
[ ] Dynami c mode
[ ] CT-Present on output 1
[ ] Process outputs if CT-Present
[ ] Fast data carrier recognition
[ ] BIS C-1../02B [x] = yes
[ ] CRC_16 data checking
< B = <– > < ESC = Exit >
Protocol Type Field:
For host devices which require a terminator, the additional use of Carriage Return 'CR' or Line
Feed with Carriage Return 'LF CR' is made available. The following page contains examples
of the various possibilities.
BIS C-6_0
Configuration
Examples for terminating telegrams:
Protocol Variants Telegram with command,
Address and no. of bytes
with Blockcheck BCC 'R 0000 0001'
with Carriage Return 'R 0000 0001'
with Terminator 'R 0000 0001'
Carriage Return
with Terminator 'R 0000 0001'
Carriage Return and Line Feed
Parameters Field:
– CT-Present on RTS
The parameter CT-Present on RTS (corresponds to the LED indicator Data carrier Present on
the BIS C-6_0 housing) can be used to allow the PC to check CT-Present using a hardware
signal. You can connect the RTS signal, for example, to the free input RI (Ring Indicator) of
the PC as this is only used with Modem operation.
– Direct data transmission
Each time a data carrier is recognized, the data will be read out depending on the configura-
tion and output to the interface. With this setting the read command in the dialog mode is
superfluous.
Protocol Type
( • ) BCC
( ) CR as terminator
( ) CR
( ) LFCR as terminator
Paging
( • ) 32 Byte
Input
( • ) Reset
( ) Head select
( ) Data bit on Data carrier
( ) Not used
< Data to BIS > < Store >
Termi-
nator
BCC
'CR'
'CR'
'LF CR'
( ) 64 Byte
< F1 = Help >
13
english
Acknow-
Terminator
ledge
<ACK> '0'
<ACK> '0'
<ACK> '0' 'CR'
<ACK> '0' 'LF CR'