Oven Function; Setting The Time - ECG MTD 206 VSS Bedienungsanleitung

Oven installation
Adjustment bolt A:
1) Attach the adjustment bolt to the upper tunnel of the oven and then you can insert the oven into the cabinet.
2) The height of the gap between the top of the cabinet and adjustment bolt A must be 1 mm.
3) Ensure that that the power cord is not tangles or crimped anywhere.
4) Check that the oven is located in the centre of the cabinet.
Adjustment bolt A
Bolt B:
1) Open the oven doors and using bolt B attach the oven to the cabinet at the installation opening of the frame.
2) Attach the plastic cover to the installation opening.
Bolt B Installation opening
3) Connect the oven into standard electrical mains. Make sure that the specified voltage and frequency value specified on the label of
the oven conforms with the value of the voltage and frequency in the mains.
If a grounded power socket will not be accessible after the installation of the product, then the oven must be connected to a bipolar
junction socket fitted with a switch and a fuse with a 3 mm separation of contacts located in an easy to access location next to the
product. The junction socket must always be accessible, even if the oven is located inside the cabinet.

OVEN FUNCTION

Operating instructions
This microwave oven uses modern electronic controls to set cooking parameters so that they better correspond to your requirements.

1. Setting the time

As soon as the oven is connected to a power socket, "0:00" will appear on the display and a beep will be sounded.
1) Press the Clock/Pre-set button, the hour digits will start to flash.
set the hours in the range 0-23 and confirm by pressing the Clock/Pre-set button, the two minute digits will begin to flash.
2) Using
set the minutes in the range 0-59 and confirm by pressing the Clock/Pre-set button. ":" will flash on the display.
3) Using
2. Cooking in a microwave oven
By repeatedly pressing Microwave, using
display in sequence (see Microwave power output table).
By pressing the Microwave button confirm and using
button and you will also start to cook.
Top tunnel
Frame
Plastic frame cover
select the desired power output. "P100", "P 80", "P 50", "P 30", "P 10", will appear on the
set the desired cooking time. Confirm by pressing the Quick Start/Start
Set the height
Adjustment bolt A
Frame
Installation opening
EN
55