Use Of A Trailer Or Child Seat; Commissioning; Stem Adjust - HNF-NICOLAI SD3 Urban Originalbetriebsanleitung

1.4.

Use of a trailer or child seat

Due to the large number of available trailer / child seats, HNF-NICOLAI can not give
general approval. Consult with HNF-NICOLAI or a qualified dealer to check the com-
patibility of the trailer / child seat with the Pedelec.
Depending on the type of trailer, the tire pressure of the rear wheel may
need to be increased. Remove the loaded trailer from the connection point
to the pedelec and hold it at the level of the connection point with your
hand. If you feel weight on your hand, you should increase the tire pressure
of the rear wheel.
When using a child seat, increase the air pressure in the wheel, above
which the child seat is located.
2.

Commissioning

This chapter explains how to get your SD3 Urban ready for the road. First, you should
inflate the tyres. The recommended air pressure can be found in section 3.1.
2.1.

Stem adjust

Your vehicle is equipped with an angle-adjustable stem. By adjusting the angle of the
stem, the height of the handlebars can be raised or lowered.
• Loosen 4 screws until stem angle can be tur-
ned
• Set new handlebar angle
• Tighten bolts with appropriate torque. Obser-
ve the information on the stem or in the table
in section 9
In a second step, the handlebar must be rotated by this angle in the opposite direc-
tion. To do this:
• Loosen all 4 screws on the clamping plate of the stem until the handlebar can
be turned.
• Turn the handlebars to the desired position
• Tighten all 4 handlebar clamping screws of the stem with the appropriate tor-
que.
70