Adjusting The Saw; Splitting Wedge Setting; Set The Cutting Height; Adjust Saw Blade Pitch - ATIKA TK 250 Betriebsanleitung

A d j u s
A d j u s
Pull the mains plug before performing
settings.

Splitting wedge setting

The splitting wedge is an important safety device as it prevents
the workpiece from recoiling
To guarantee the function of the splitting wedge, its
distance from the toothed wheel its distance from the teeth
of the saw blade above the table must not be more than 3-5
mm.

Set the cutting height

The cut height can
be adjusted stepless
from 0 - 73 mm using
the crank (11).
Before setting the cut
height, tighten the
set screw for the saw
blade (9).
Set the cutting height
5 mm higher than the
material thickness.

Adjust saw blade pitch

The saw blade must not be set to the inclined position
when the blade is turning. The motor must be switched
off first.
Adjusting between 0° - 45°
1. Loosen the clamping
screw (9).
2. Turn the handwheel until
the required angle is
shown (0° - 45°).
3. Retighten the set screw.
18
t i n g t h e s a w
t i n g t h e s a w
Adjusting the angle indicator:
1. Turn the machine off and unplug the power cord.
2. Use an angle stop to align the saw blade vertically.
3. Loosen the screw (A) and slide the angle indicator to the 0°
mark.

Fitting and adjusting the transverse stop

The transverse stop supplied can be used as a
transverse or mitre stop.
Setting the angle. Loosen the clamping screw of the
transverse stop by turning.
Fit the transverse stop to the saw table plate
Push the transverse stop into one of the two grooves
on the saw table plate.
Setting the angle
Loosen the clamping screw of the transverse stop by
turning. You can now set the stop to the required angle.
Turn the clamping screw tight again.

Fitting and adjusting the longitudinal stop

Fit the longitudinal stop to the saw table plate.
The longitudinal stop (6) can be installed on the left or right of
the saw blade. To attach the fence (6A) on the other side of the
stop,
remove the fence,
unscrew the two knurled nuts,
attach the guide plate on the other side of the stop,
reinstall the fence.