Hama EWS-152 Bedienungsanleitung Seite 8

Manually setting the date/time
• Press and hold the
signal. The wireless symbol (6) goes out and you can set the time manually.
• Press and hold the MODE button (8) for approx. 3 seconds to start manually setting
the date/time.
• Set the following information in the order listed:
• Time zone (difference in hours), hour, minute.
• To select individual values, press the
selection by pressing the MODE button (8). .
• If you do not make an entry for 20 seconds, you automatically exit setup mode.
Note – Time zone
• The DCF signal can be received over long distances, but always transmits the current
Central European Time in Germany. Make sure you account for the time difference in
countries with another time zone.
• If you are in Moscow, the time is 3 hours later than in Germany. This means that you
should set +3 for the time zone. The clock then automatically sets the time to 3 hours
after the DCF signal received or relative to the manually set time.
Celsius/Fahrenheit
• Press the button (9) to switch between °C and °F for the temperature display.
12/24 hour format
• Press the button (7) to switch the time between the 12 and 24 hour format.
6.3 Low battery capacity
As soon as the battery symbol (2) appears on the display of the base station, the capacity of
the batteries in the measuring station is very low. Replace the batteries immediately.
Note – Replacing the batteries
• Note that the stations have to be resynchronised each time after you change the
batteries in the measuring or base station.
• To do this, remove the batteries from the other station and then reinsert them, or
change them as required.
7. Care and Maintenance
Only clean this product with a slightly damp, lint-free cloth and do not use aggressive
cleaning agents.
button (9) for approx. 3 seconds to stop the search for the DCF
button (7) or the button (9) and con rm each
7