Dustbin Emptying - Xiaomi Roborock S7 MaxV Plus Bedienungsanleitung

Washable Filter
C6
* Clean every 2 weeks and replace every 6-12 months.
C6-1— Open the filter cover and remove the
filter.
C6-2— Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Note: Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
C6-3— Allow 24 hours for the filter to dry
thoroughly and reinstall it.
Note: Purchase an additional filter and alternate if necessary.
Water Tank
C7
* Clean as required.
C7-1— Open the water tank and fill it with
clean water.
C7-2— Close the water tank and shake it
gently.
C7-3— Pour out the remaining water as
shown.
VibraRise Mop Cloth
C8
* Clean after each use and replace every 3-6 months.
C8-1— Remove the VibraRise mop cloth from
the VibraRise mop bracket. Clean the
VibraRise mop cloth and air-dry it.
Note: A dirty VibraRise mop will affect the mopping
performance. Clean it before use.
Robot Sensors
C9
* Clean monthly.
Use a soft, dry cloth to wipe and clean all
sensors, including:
C9-1— ReactiveAI Obstacle Recognition
C9-2— Wall Sensor
C9-3— Mop Wash Sensor
C9-4— Carpet Sensor
C9-5— Cliff Sensors
Charging Contact Areas
C10
* Clean monthly.
Use a soft dry cloth to wipe the charging
contacts on the robot.
Battery
The robot is equipped with a built-in
high-performance lithium-ion rechargeable
battery pack. To maintain battery
performance, keep the robot charged
during normal use.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.

Dustbin Emptying

C11
* Clean monthly.
Notes:
• To ensure optimal performance, clean the dustbin regularly
or when the dust reaches the MAX mark.
• After using the cyclone separator, there may be a small
amount of debris such as hair or dust left in the dustbin.
This is normal and will not affect performance.
013
C11-1— Remove the dustbin vertically as
shown.
C11-2— Hold the dustbin approx. 15 cm
(6 in) over a bin then press the
Dustbin Opener.
C11-3— After emptying, close the bottom
lid and reinstall the dustbin on the
dock.
Dustbin & Cyclone
C12
Separator Cleaning
* Clean as required.
Notes:
• To avoid potential corrosion, do not use detergents,
polishes or air fresheners to clean the dustbin or cyclone
separator.
• Do not wash the dustbin or cyclone separator in a
dishwasher or washing machine.
C12-1— Empty the dustbin and remove the
cyclone separator.
C12-2— Rinse the dustbin and cyclone
separator with cold water until
clean.
C12-3— Leave the dustbin and cyclone
separator to dry for 24 hours or
until completely dry.
C12-4— Rotate the cyclone separator as
shown to install it back in the
dustbin and close the bottom lid.
C12-5— Reinstall the dustbin in the dock.