Sensor Calibration - Moza AirCross 2 Benutzerhandbuch

Sensor Calibration

Gyroscope Calibration
Turn on the gimbal and leave it quietly for 5 minutes, the gyroscope calibration is
required when the gimbal drifts obviously.
The steps are as follows:
Turn on the gimbal (long press the power button)
•
Turn off the motors (double press the power button/enter the menu, select
•
gimbal>motor>switch, set 'off')
Place air 2S on a horizontal table so that the platform is completely horizontal, keep
•
the stabilizer stationary, and do not wiggle or tilt the stabilizer.
Enter the menu, select advanced>calibrate>Gyro cali and press the dial right button,
•
wait about 5 seconds, when the ' ? ' changes to 'OK', the calibration is completed.
Accelerometer Calibration
Turn on the gimbal and there is no obvious drift, the accelerometer calibration is
required when the camera doesn't keep level.
The steps are as follows:
Turn on the gimbal (long press the power button)
•
Turn off the motors (double press the power button/enter the menu, select
•
gimbal>motor>switch, set 'off')
Leave the L-shaped quick release plate on the horizontal table. Avoid the bottom
•
screw and keep the Air 2S at static position. Do not shake it or tilt it. (or mount the
camera to refer to its level)
Enter the menu, select advanced>calibrate>Acc cali, and press the dial right button
•
to enter calibration. Wait about 5 seconds, when the ' ? ' changes to 'OK', the
calibration is completed.
Note:
1. Please keep the gimbal stationary during the calibration, any shaking will
cause the calibration to deviate.
2. Any drastic shaking might cause 'err' shown on the screen, please calibrate
again.
3. Do not arbitrarily perform calibration operations while it is not necessary.
Keep Level
26