Safety Warnings - Marmitek HomeGuard MS8000 Gebrauchsanleitung

seCurITY sYsTem WITh BuILT-IN TeLePhoNe dIaLLer

saFeTY WarNINgs

• To prevent short circuits, this product should only be used inside and only in dry spaces. Do
not expose the components to rain or moisture. Do not use the product close to a bath,
swimming pool etc.
• Do not expose the components of your systems to extremely high temperatures or bright
light sources.
• In case of improper usage or if you have altered and repaired the product yourself, all
guarantees expire. Marmitek does not accept responsibility in the case of improper usage
of the product or when the product is used for purposes other than specified. Marmitek
does not accept responsibility for additional damage other than covered by the legal
product responsibility.
• This product is not a toy. Keep out of reach of children.
• Do not open the product (battery panel excepted): the device may contain live parts. The
product should only be repaired or serviced by a qualified repairman.
• Keep batteries out of the reach of children. Dispose of batteries as chemical waste. Never
use old and new batteries or different types of batteries together. Remove the batteries
when you are not using the system for a longer period of time. Check the polarity (+/-)
of the batteries when inserting them in the product. Wrong positioning can cause an
explosion.
• Only connect the adapter to the mains after checking whether the mains voltage is the same
as the values on the identification tags. Never connect an adapter when it is damaged. In
that case, contact your supplier.
1. FuNCTIoNs summerY
After entering your PIN code, use the keys to program the following:
'1' + 'ARM' (on KR21E) + any random key: log-on your remote control (see chapter 7).
'2' + '*' + 'telephone number' + '#': + 1, 2 or 3: telephone numbers (see chapter 6).
'3' + '*' activate siren, '#': set silent alarm (see chapter 9).
'4': decide number of beeps (1, 2 or 3) after message (see chapter 6).
'5': enter new PIN code (see chapter 5).
'6' + '*': activate PIR, '#': switch PIR off (see chapter 10).
'7' + '*': delay alarm, '#': set instant alarm (see chapter 8).
'#': activate alarm (see chapter 11).
'*': de-active alarm (see chapter 11).
2. ImPorTaNT FuNCTIoNs aNd CoNTroLs:
1. Keyboard:
Open the cover by pulling the front panel forward.
2. passive infrared Sensor (pir):
Detects motion within a 6 meter range at an angle of 180˚, 12 meter straight forward.
HomeGuard™ 3