Technical Data; Unpacking; Assembly / Before Commissioning - Scheppach 5905421902 Original Bedienungsanleitung

6. Technical data

Dimensions DxWxH
mm
Swivel table height mm
Working height mm
Wood length cm
Max. power t*
Hydraulic pressure MPa
Cylinder stroke cm
Feed speed cm/s
Return speed cm/s
Oil quantity l
Min./max. wood diam-
eter cm
Weight kg
Drive
Motor V/Hz
Rated input P1 kW
Power output P2 kW
Input current A
Short-circuit resistance
kA
Operating mode
Speed 1/min
Motor protection
Phase inverter
Technical changes reserved!
* The maximum achievable splitting force is depend-
ent on the resistance of the log and can differ due to
variable contributing factors on the hydraulic system.
Compact Compact
12t 15t
1160x960x1100 / 1650
320
920
1070 / 750
12 15
23,3 25,6
55,0
5,2 5,2
22 22
8,0
9 – 40
191
400/50 400/50
3,5 3,5
2,5 2,5
14
1
S6/40% / IP54
2800
Yes
Yes
www.scheppach.com
7.

Unpacking

• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Replace-
ment parts can be obtained from your dealer.
• When ordering please provide our article number as
well as type and year of manufacture for your prod-
uct.
m WARNING!
Danger of choking and suffocating!
The packaging material, packaging and transport safe-
ty devices are not children's toys. Plastic bags, foils
and small parts can be swallowed and lead to choking.
- Keep packaging material, packaging and trans-
port safety devices away from children.

8. Assembly / Before commissioning

m Attention!
Always make sure the device is fully assembled before
commissioning!
Your scheppach log splitter is not completely assem-
bled for packaging reasons.
Fitting control arms, Fig. 7
• Lightly grease the sliding plate (5d).
• Insert the control arm (5) with the recess into the
cross-connection (5c).
• Insert M 8 x 30 hexagonal bolt, (5b) with washer
from above, tighten with washer and locknut from
below so that the control arm can still be moved.
• Mount the left control arm 5a in the same way (5c)
Fig.8, also guide the upper rocker switch through the
switch rod recess (5d) Fig.1
GB | 39