Stirrer On/Off Swipe Field; Interfaces - Heidolph Hei-TORQUE Expert Betriebsanleitung

Device description

Stirrer on/off swipe field

Stirrer on/off
The [
at the switched on device:
➜ Swipe a finger from left to right or from right to left over the field to start and
re-stop the rotational movement.
Starting and stopping the rotational movement does not have any
effect on the device's [
the rotational movement merely stops the stirrer tool, the device
remains switched on.
The direction of the swipe movement on the swipe field does not
have any influence on the rotational direction of the stirrer tool.

Interfaces

The Hei-TORQUE Ultimate type devices provide two serial interfaces at the back of the
housing:
– 1 × USB Micro type AB
– 1 × RS232 SUB D9
Use these interfaces to connect the device to a PC for external activation.
WARNING
Electric Shock
If the voltages at the connection sockets are too high and insulation
is inadequate, voltage can be applied to metallic parts such as the
housing in case of a fault.
➜
➜
Damage due to penetrating liquid
➜
] swipe field is used to start and stop the rotational movement
on/off
Extra-low voltage inputs and outputs above 25 V AC or 60 V DC
respectively must be disconnected safely according to EN 61140
or must be protected by doubled or increased insulation in
accordance with EN 60730-1.
Only use shielded connection cables and connect the shielding to
the connector housing.
Make sure that the interface connections at the back of the
device are secured by the covers provided.
] operating state, i.e. stopping
60