Low Battery Indication; Backlight - Technoline WS9480 Bedienungsanleitung

or "▼" (B8) button to adjust the alarm time. Press "MODE" button (B1) to confirm the setting.
Press "AL ON/OFF" button (B2) to switch alarm on or off. If it is on, "

When Alarming, press "SNOOZE / LIGHT" button (B4) to activate the snooze alarm, ("

the LCD). The alarm will snooze for around 5 minutes, then it alarms again. This snooze function can
be enabled for maximum 7 times.
Except "Snooze" button, press any buttons to stop the snooze alarm. Otherwise, the alarm signal

sounds for about 2 minutes, and then stops automatically.

8. Low battery indication:

The low battery icon "
batteries should be replaced.

9. Backlight

Press "SNOOZE/LIGHT" button (B4), back light states for 5 seconds.
10. Precautions
Use a pin to press the reset button (B5) if the unit does not work properly.

Avoid placing the clock near interference sources/metal frames such as computer or TV sets.

The clock loses its time information when the battery is removed.

Do not expose it to direct sunlight, heavy heat, cold, high humidity or wet areas

The outdoor sensor must not be set up and installed under water. Set it up in away direct sunlight and Rain

Never clean the device using abrasive or corrosive materials or products. Abrasive cleaning agents may scratch

plastic parts and corrode electronic circuits
Hereby, Technotrade declares that these products WS 9480 and TX80TH are in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU and ROHS 2011/65/EC. The original EU declaration of
conformity may be found at: www.technoline.de/doc/4029665094809
11. Specifications
Indoor Data:
Temperature range:
Temperature Units Measured:
Humidity Range:
Outdoor Data:
Transmission distance:
(open area)
"will appear l indicating that thermo sensor is in low battery status. The
-10 to 50°C
°C or °F [switchable]
20% to 99%
100m @ 433MHz
EN7
" show on the LCD.
" flash on