Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Index
2
1. General information
2
Weight
2
The home owner must ensure that the floor can
2
withstand the load according to the total weight of the
2
fireplace. When installing the product on a floating wood
2
floor, the floor boards underneath the fireplace must be
2
removed, this to avoid the that the floor boards lock and
3
3
crack.
3
Adjustment
3
We recommend to stack the surround without glue in
3
order to adjust the insert prior to perforating the chimney
3
4
for the flue connection. Use a spirit level to ensure that
4
the surround is mounted straight. The insert will expand
with heat and for this reason the surround must not rest
4
on the insert. (Above the insert there must be a gap
4
of 3 to 5 mm. Laterally there is no need for gaps, but
4
between the lower part of the insert and the surround
4
there must be a gap of at least 2 mm.)
5
Floor plate
5
A fireproof floor plate must be put in front of the fireplace
5
if the floor is of a combustible material.
5
5
Acrylic glue
5
The fireplace is to be assembled using acrylic glue.
5
6
Make sure all dust is removed and that the surfaces are
clean. When the fireplace is assembled, use the same
6
acylic glue for filling joints (FIG Z)
6
Minor damage
8
The fireplace can sustain minor damage during
transport and handling.
This can be repaired with acrylic/light filler. For perfect
results, you can fill and sand with a suitable filler. Minor
damage and uneven surfaces can be filled. If the
damage is deep or in the event of significant damage,
you are recommended to fill repeatedly with tile
adhesive or cement putty to avoid sinking. Smooth off
with e.g. a damp sponge or a float.
Fine Fissures
The building material around the fireplace can move.
In new houses in particular, it is common for building
materials to settle substantially in the early years. In
addition, all concrete elements shrink to a decreasing
extent for up to 15 months.
The result is that small cracks may appear in the
concrete/masonry.
Use the fireplace for a few months. If cracks appear,
scrape them out with a screwdriver or similar (to provide
more space for acrylic joint filler). Vacuum the surfaces
to remove any dust.
Inject acrylic joint filler and even it out with a spatula or a
finger wetted with soapy water.
The joint can be painted after a couple of days.
GB
Werbung
Kapitel
Inhaltsverzeichnis
