Kärcher B 95 RS Originalbetriebsanleitung Seite 20

Loosen all three screws to incline the
suction bar.
Set the incline.
Tighten the screws.
Turn or replace vacuum lips
Release the wing nuts.
Remove the vacuum bar.
Unscrew the star grips.
Remove the plastic parts.
Remove the vacuum lips.
Turn the vacuum lips or insert new
ones.
Insert the plastic parts.
Screw in and tighten the star grips.
Mount splash guard
Select the floor clearance of the spray
guard by turning the adjustment wheel.
Replacing the brush rollers
Lift the cleaning head.
Open the spray guard lock.
Swivel the spray guard to the side.
Loosen the lock of the wiper flap.
Push the bearing lid down and remove.
Pull out the brush roller.
20
All manuals and user guides at all-guides.com
Insert a new brush roller.
Reassemble the bearing lid in the re-
verse sequence.
Repeat process on the opposite side.
Maintenance tasks BD 60/95 RS
Setting the Vacuum Bar
Drive the device on a smooth surface.
Lower the vacuum bar.
Drive at least 60 cm forward.
Stop the device, turn key to "0" and re-
move it. Ensure that the device does
not roll backward.
1 Levelling adjustment
2 Cross-handle for height adjustment
-
Align the vacuum bar using the cross-
handles in such a way that the rear vac-
uum lip is bent backward (symmetrical
to the centre) on both sides of the vac-
uum bar.
Adjust the levelling in such a way that
the rear vacuum lip is bent much to-
wards the back across the entire length.
To check the setting, drive 60 cm for-
ward and check the effect of the new
setting.
Adjust the vacuum bar by simultane-
ously turning both the cross-handles in
such a way that the rear vacuum lip is
bent almost 9 to 10 mm backward.
In clock-wise direction: Bend is lesser.
Anti-clockwise direction: Bend be-
comes larger.
To check the setting, drive 60 cm for-
ward and check the effect of the new
setting.
Dismantling the vacuum bar
Raise the vacuum bar.
Turn key to "0" and remove it.
Pull out the suction hose from the vacu-
um bar.
EN
-
1 Cross handle for fastening of vacuum
bar
Loosen the cross-handles of the vacu-
um bar fastening and pull out the vacu-
um bar towards the side.
Turn/ replace front vacuum lip
Dismantle the vacuum bar.
1 Wing bolt
2 Pressure plate
3 Vacuum lip
Loosen the wing nuts.
Remove the pressure plate.
Take out the vacuum lips.
Note
The vacuum lips can be turned thrice till all
edges are worn off. After that you need a
new vacuum lip.
Turn the vacuum lip or replace and in-
sert it back into the vacuum bar and
align.
Replace pressure plate.
First tighten the central wing bolt. En-
sure that the pressure plate is lying firm-
ly on the vacuum lip.
Tighten the remaining wing bolts.
Turn/ replace rear vacuum lip
Dismantle the vacuum bar.
1 Clamping lock
2 Strap
3 Vacuum lip
7