Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3. Cut 8m long cutting line, Insert the line into the
EN
mounting hole inside the eyelet (Fig. O1). Push and
pull the line from the other side until equal amounts
of line appear on both sides of the spool.
4. Press, while rotating the lower cover assembly in the
arrow direction, to wind the line onto the spool until
approximately 14cm of line is showing on each side
(Fig. O2).
5. Push the lower cover assembly down while pulling on
the lines to manually advance the line and to check
for proper assembly of the trimmer head.
When the cutting line breaks from the line outlet or the
cutting line is not released when the trimmer head is
tapped, follow the steps below:
1. Press the release tabs on the upper cover and
remove the lower cover assembly by pulling it
straight out (Fig. K1 & K2).
2. Remove the cutting line from the spool .
3. With one hand holding the lower cover assembly, use
the other hand to grasp the lower cover assembly
and align the tabs on the upper cover with the holes
in the lower cover assembly (Fig. O3); Use your palm
to press the lower cover assembly until the tabs lock
with the upper cover.
4. Follow the instructions in "LINE REPLACEMENT" to
reload the cutting line.
MAINTENANCE
WARNING: When servicing, use only identical
replacement parts. Inspect and maintain the machine
regularly. To ensure safety and reliability, all repairs
should be performed by a qualified service technician.
WARNING: Battery tools do not have to be
plugged into an electrical outlet; therefore, they are
always in operating condition. To prevent serious
personal injury, take extra precautions and care when
performing maintenance, service or for changing the
cutting attachment or other attachments.
WARNING: To prevent serious personal injury,
unplug the battery connector from the socket before
servicing, cleaning, changing add-on attachments or
removing material from the unit.
LUBRICATE THE GEAR CASE
For best operation and longer lifetime, lubricate the gear
case with a special grease (4-5g each time) after every
50 hours operation.
10
56 VOLT LITHIUM-ION CORDLESS LINE TRIMMER — STX3800
The special grease should meet the following
requirements.
1. Belong to DIN51818: NLGI-1 cone penetration
degree.
2. Ester base grease.
3. Excellent low-temperature startup, EP, mechanical
shearing, abrasion resistance and oxidative stability
properties.
4. Operation temperature must contain -40~180°C.
Remove the battery plug and the sealing screw.
Lubricating the gear case through the oil-hole.
WARNING:
Do not lubricate while the brush cutter
is still connected with battery or running.
CLEANING THE UNIT
◾
Clean the unit using a damp cloth with a mild detergent.
◾
Do not use any strong detergents on the plastic
housing or the handle. They can be damaged by certain
aromatic oils, such as pine and lemon, and by solvents
such as kerosene. Moisture can also cause a shock
hazard. Wipe off any moisture with a soft dry cloth.
◾
STORING THE UNIT
◾
Unplug the battery connector from the socket from the
line trimmer when it is not in use.
◾
Clean the tool thoroughly before storing it.
◾
Store the unit in a dry, well-ventilated area, locked-up
or up high, out of the reach of children. Do not store
the unit on or adjacent to fertilizers, petrol, or other
chemicals.
◾
Use of a transport cover for metal blades during
transport and storage.
Protecting the environment
Do not dispose of electrical equipment,
used battery and charger into household
waste! Take this product to an authorized
recycler and make it available for eparate
collection. Electric tools must be returned
to an environmentally compatible
recycling facility.
Werbung
Inhaltsverzeichnis
