Checking The Controls; Checking Chain Lubrication; Testing The Battery; Operating The Saw - Stihl MSA 160 C Gebrauchsanleitung

11 Operating the Saw

WARNING
■ The chain's cutters are very sharp. There is a
risk of cut injuries.
► Wear work gloves made of durable mate‐
rial.
► Try to pull the chain along the guide bar by
hand.
If the chain cannot be pulled along the bar by
hand, the chain brake is functioning.
► If the chain can be pulled along the bar by
hand: Do not use your chain saw and contact
your STIHL servicing dealer.
The chain brake is defective.
10.5

Checking the controls

Lockout button and trigger
► Engage chain brake and remove battery.
► Attempt to pull the trigger lever without
depressing the lockout button.
► If the trigger can be pulled: Do not use your
chainsaw and contact your STIHL servicing
dealer.
The lockout button is defective.
► Press and hold the lockout button.
► Press and release the trigger.
► If the trigger is stiff or does not spring back to
its idle position: Do not use your chainsaw and
contact your STIHL servicing dealer for assis‐
tance.
The trigger is defective.
Switching on the chainsaw
► Insert battery.
► Disengage the chain brake.
► Press and hold the lockout button.
► Press and hold the trigger.
The saw chain starts running.
► Release the trigger.
The saw chain stops running.
► If the chain continues to rotate: Engage the
chain brake, remove the battery and contact
your STIHL servicing dealer.
Your saw has a malfunction.
10.6

Checking Chain Lubrication

► Fit the battery.
► Disengage the chain brake.
► Hold the guide bar over a light surface.
► Switch on the saw.
Chain oil is thrown off the chain and is visible
on the light surface. Chain lubrication is oper‐
ating properly.
► If no chain oil can be seen:
► Fill up with chain oil.
0458-701-9621-C
► Check chain lubrication again.
► If chain oil is still not visible on the light sur‐
face: Do not use your chain saw and con‐
tact your STIHL servicing dealer. Chain
lubrication is defective.
10.7

Testing the Battery

► Press button on battery.
The LEDs glow or flash.
► If the LEDs do not glow or flash: Do not use
the battery and contact your STIHL servicing
dealer.
There is a malfunction in the battery.
11 Operating the Saw
11.1 Holding and Controlling the
Chainsaw
1
► Hold and control the chainsaw with your left
hand on the handlebar and your right hand on
the grip area (1) of the control handle so that
your left thumb wraps around the handlebar
and your right thumb wraps around the control
handle.
11.2 Sawing
WARNING
■ If kickback occurs, the chainsaw can be
thrown up in the direction of the operator. This
may result in serious or fatal injury to the user.
► Always cut with the chain running at full
speed.
► Do not cut with the upper quadrant of the
guide bar nose.
► Begin the cut with the chain running at full
speed and keep the guide bar vertical.
English
45