Assembly Instructions; Description (Fig. A); Package Contents (Fig. B & C); Assembly (Fig. D) - Tunturi Cardio Fit B30 Bike Benutzerhandbuch

English
- Do not use or store the equipment in humid
surroundings. The air humidity must never be
more than 80%.
- Only use the equipment for its intended
purpose. Do not use the equipment for other
purposes than described in the manual.
- Do not use the equipment if any part is
damaged or defective. If a part is damaged or
defective, contact your dealer.
- Keep your hands, feet and other body parts
away from the moving parts.
- Keep your hair away from the moving parts.
- Wear appropriate clothing and shoes.
- Keep clothing, jewellery and other objects away
from the moving parts.
- Make sure that only one person uses the
equipment at a Time. The equipment must not
be used by persons weighing more than 110 kg
(242 lbs).
- Do not open equipment without consulting
your dealer.

Assembly instructions

Description (fig. A)

Your upright bike is a piece of stationary fitness
equipment used to simulate cycling without
causing excessive pressure to the joints
Package contents (fig. B & C)
- The package contains the parts as shown in
fig. B.
- The package contains the fasteners as shown in
fig. C. Refer to the section "Description"
‼ NOTE
• If a part is missing, contact your dealer.

Assembly (fig. D)

⚠ WARNING
• Assemble the equipment in the given order.
• Carry and move the equipment with at least
two persons.
⚠ CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to
prevent damage to the floor surface.
14
• Allow at least 100 cm of clearance around
the equipment.
• Refer to the illustrations for the correct
assembly of the equipment.
‼ NOTE
• Save the tools provided with this product,
after you completed the product assembly,
for future service purposes.

Extra bolts ( Fig D-6)

The two extra bolts and commencing washers
on the front side of the upright tube are pre
assembled to fit an additional tablet holder.
The tablet holder does not come standard with
the product, but can be purchased separately as
an accessory
Order for Tunturi article number: 16TCFTH010
‼ NOTE
• This accessory does not come standard with
this product. Use

Adjusting the support feet

The equipment is equipped with 2 support feet. If
the equipment is not stable, the support feet can
be adjusted.
- Turn the support feet as required to put the
equipment in a stable position.
‼ NOTE
- The machine is the most stable when all
support feet are turned fully in. Therefore start
to level the machine by turning all support feet
fully in, before turning out the required support
feet to stable the machine. .
Adjusting the vertical seat position
The vertical seat position can be adjusted by
setting the seat tube to the required position.
With the leg almost straight, the arch of the foot
must touch the pedal at its lowermost point.
- Loosen the seat tube adjustment knob.
- Move the seat tube to the required position.
- Tighten the seat tube adjustment knob.