Product Safety Information; Product Specifications - Ingersoll-Rand 211 Technische Produktdaten

Product Safety Information

Intended Use:
These Air Impact Wrenches are designed to remove and install threaded fasteners.
For additional information refer to Product Safety Information Manual Form 04580916.
Manuals can be downloaded from ingersollrandproducts.com.
Power Management System
For models that include a power management system, the system allows operator reduction of
maximum output power in either the forward or the reverse direction. For reduced power in
the forward direction and full power in the reverse direction, push the reverse valve inward
on the right side of the tool and rotate the reverse valve until the notch on the right side aligns
with the desired number on the right side. This provides reduced power in forward but full power
in reverse when the reverse valve is pushed in the opposite direction. (See TPD1248 on page 2.)
For reduced power in the reverse direction and full power in the forward direction, push the
reverse valve inward on the left side of the tool and rotate the reverse valve until the notch on the
left side aligns with the desired number on the left side. This provides full power in forward but
reduced power in reverse when the reverse valve is pushed the opposite direction. (See TPD1249
on page 2.) For full power in both directions, rotate the Reverse Valve until the notch on either
end of the Reverse Valve aligns with 5 on each side of the housing. The power level indicators
(See TPD1248 and TPD 1249) are for reference and DO NOT indicate a specific power. The power
output can be further reduced in forward or reverse by using the variable throttle.

Product Specifications

Model(s) Style
211 Straight
211-EU Straight
212 Pistol
212-EU Pistol
Model(s)
211
211-EU
212
212-EU
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.
04584736_ed8
Drive
Impacts per
Min.
Type Size
Square 3/8" 1500
Square 3/8" 1500
Square 3/8" 1500
Square 3/8" 1500
Sound Level dB(A)
(EN ISO 15744)
† Pressure (L )
p
101.0
101.0
94.5
94.5
WARNING
Recommended Torque Range
Forward
ft-lb (Nm)
20-125 (27-170)
20-125 (27-170)
20-125 (27-170)
20-125 (27-170)
‡ Power (L )
w
112.0
112.0
105.5
105.5
*K = Vibration measurement uncertainty
EN
Reverse
ft-lb (Nm)
20-125 (27-170)
20-125 (27-170)
20-125 (27-170)
20-125 (27-170)
Vibration (m/s²)
(EN ISO 28927-2)
Level * K
5.9 1.6
5.9 1.6
6.5 1.0
6.5 1.0
EN-1