BOMANN DU 7600 IX Bedienungsanleitung, Garantie Seite 19

WARNING:
 Failure to use the mounting fixtures may lead to a
risk of electric shock.
CAUTION:
 Before mounting, check that the wall has enough
loading capacity to bear the cooker hood.
 When drilling the holes in the wall always make
sure that no existing electrical cables or other ob-
jects are damaged.
 Make sure that the ventilation slots are clear of
obstacles and are not covered.
NOTE: Recommendations for preparation work
 When installing, ask another person to assist.
 Wear protective gloves to prevent injuries from
any sharp edges.
Drilling dimensions
Fig. 1
Fig. 3
Unit mm
Fig. 2
Fig. 4
Fig. 5
 Determine the position of the cooker hood central-
ly above the cooking area in accordance with the
specified safety distances.
Totally 6x mounting holes with a diameter of approx.
8 mm are necessary for the wall mounting. Insert the
(Fig. 1).
supplied dowels
 First, drill the holes for attaching the housing ac-
cording to the enclosed drilling template. Check
the markings with a spirit level first!
Turn in the upper screws 2x ST4*30mm for the
-
suspension of the housing so far that they pro-
ject approx. 5 mm out of the wall.
 Fasten the bracket for the upper shaft termination
with the screws 2x ST4*40mm; after determining
the extension length of the shaft cover.
For extraction mode:
(supplied) with an inner diameter of 150 mm onto the
connecting piece (extraction duct)
Secure the hose with a zip tie.
 Hang up the housing. Check the secure hold and
the horizontal position
For extraction mode:
the exhaust hose and connect it with the outlet open-
ing.
 Put on the telescoped shaft unit and tighten the
lower screws 2x ST4*30mm through the housing
(Fig. 4)
to secure it
 Pull up the inner shaft and fix the shaft cover lat-
erally to the shaft closure bracket using self-
tapping screws 2x ST4*8mm
19
Attach a flexible exhaust hose
(Fig. 2).
(Fig. 3)
.
Check the correct position of
.
(Fig. 5)
.