Changing Saw Rail And Saw Chain - Zipper Maschinen ZI-HET40V-AKKU Betriebsanleitung

14.2.2 Changing saw rail and saw chain

An incorrectly attached saw chain will cause the power tool to cut in an
uncontrolled manner! When attaching the chain, observe the specified running
direction!!
 Place the pole saw on any suitable flat surface.
 Unscrew the handwheel anti-clockwise until the saw rail
can be moved by hand (1.).
 Turn the chain tensioning wheel clock-wise to push the
saw rail as far as possible onto the chain wheel (2.).
 Detach the handwheel (3.) and remove the chain cover
(4.).
 Place saw chain around the saw rail starting on the upper
part of the rail. Slide the chain in the slot around the saw
rail.
When attaching the chain, ensure that it is in the
correct running direction!
 Place the saw chain around the chain wheel (5.).
 Place elongated hole of the saw rail on the stud bolt and
the guide bolt (6.).
 Attach the chain guard (7.). Tighten the handwheel
slightly (8.).
 Tighten the chain tensioning wheel anti-clockwise to
tension the chain (9.).
The saw chain must not sag, but it should be possible to pull
it 2-3 mm off the saw rail in the middle of the saw rail.
 Tighten the handwheel to attach the rail and the cover
(10.).
 Turn the saw chain by hand to check that it runs
perfectly. It must slide freely in the rail
NOTE: Check and re-adjust the tension of a new chain after working for a few minutes. Switch the
motor off, remove the battery and actuate the chain brake!
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-HET40V-AKKU
A T T E N T I O N
MAINTENANCE
35