Ip Camera Configurations; Connection To Ip Network With Dhcp Service - urmet FISHEYE Serie Schnellanleitung

EN

IP Camera Configurations

The camera must be configured for the home or office network after it has been powered.
It is advisable to install and configure one camera at a time if you are installing multiple
cameras on the same network.

CONNECTION TO IP NETWORK WITH DHCP SERVICE

For Quick installation about IP camera with dynamic host configuration (DHCP) on the
network will be assigned an IP address automatically. IF DHCP Service is not supported,
the default IP Address of IP Camera will be 192.168.1.168.
IP Camera Configuration:
1. Install the Software "Device Config. Tool" provided by CD and follow the installation
instructions displayed at monitor.
2. Launch the "Device Config. Tool" Software, selecting
automatically IP Address, Subnet Mask, Gateway, and MAC Address for each IP
Camera detected in LAN, as shown in picture below.
DS1093-575 22
it will be displayed