EUROM Flow 250 Bedienungsanleitung Seite 20

Pump runs but
does not pump
water
Pump does not
switch off
Insufficient water
Pump does not
start or suddenly
switches off while
functioning
Pump suddenly
provides less
water
Guarantee
The submersible pump you have purchased comes with the usual guarantee which
applies to production and material defects.
The following damage and defects are not covered by the guarantee:
 Wear and tear and defects in relation to mechanical seals caused by drying out
or the presence of specific substances and/or objects in the water.
 Blockage of the blade by foreign objects
 Transport damage
 Damage caused by unreasonable use
 Defects that unauthorised persons have attempted to resolve or which have
been caused by improper repairs
 Damage due to overheating
Inlet openings are
-
clogged
Water drainage pipe is
-
bent or hose is blocked
Air around the blade
-
- Blade is jammed
- Water level is too low
(manual usage)
Float cannot sink
-
Inlet openings are
-
(partially) blocked
Too little pumping
-
capacity due to
contamination and dirty
water
Thermal safeguard stops
-
pump due to overheating
Water is too hot
-
Power outage
-
Dirt or stones in the
-
water supply
Suction openings are
-
blocked
Hose is blocked
-
Clean them
-
Straighten the hose or
-
remove the blockage
Switch the pump off and
-
move it from side to side.
Wait until the air has escaped
and switch on again
Try to remove the blockage
-
or ask a professional to do so
Submerge the pump in
-
deeper water
Give the float more space
-
Clean them
-
Clean the pump and replace
-
worn out parts
See: overheating safeguard
-
Max. water temperature 35°C
-
Check fuses and earth
-
leakage
Remove dirt and stones
-
Clean the openings
-
Clean it
-
20