Technical Specifications - Fulbat FULLOAD 750 Bedienungsanleitung

opens under severe overload. This condition may occur if attempting to charge any severely discharged
or heavily sulfated battery. Once the Interrupter opens, the charger will stop charging for a short period
and then resume charging automatically and the yellow. L.E.D. will be OFF, until resume charging.
Overloading could be due to an external load, remove the load condition prior to attempting to recharge
the battery.
 Reserve Battery / Overload Condition: The charger has reverse battery and short circuit protection.
If a reverse battery condition exists (White L.E.D. will turn RED, only, while output leads are
connected backwards), simply unplug charger from AC power and properly remake the connections
as described in this manual
 Internal over heat protection: FULLOAD Chargers have an internal overheat protection. The power
will be reduced of the ambient temperature is raised.
 Corrosion-resistant output connectors
 Output clips and ring terminals provided: It comes with a quick connect fly lead and 2 different
kinds of connectors, crocodile clips and a ring terminals. The ring terminals are perfect for
permanent connection to your battery. You can connect the lead to the battery and tuck the lead away
while you are using your vehicle and when you get back to your garage simply plug the lead back
into the charger
BATTERY TYPES & CAPACITY:
 Suits all Lead Acid Type Batteries. (Conventional, AGM & Gel)
 Selectable 6 Volt & 12 Volt Output
 Battery Capacity:
o The following maximum AH capacities are to be used as a general guide only: some batteries
maybe able to handle a higher Charge Current. Check with the battery Manufacturer when
charging batteries with small capacity.
Charge Current:
Battery Capacity: Charging:
Battery Capacity: Maintaining:
:
ELECTRICAL PARTS:
Delivered with:
 Input:50cm
 Output:150cm
 Short cable with alligator: 30cm
 Short cable with ring terminal: 30cm
ENVIRONMENTAL CHARACTERISTICS:
 Operating Temperature: 0 to 45° C
 Storage Temperature: -25 to 85°C
 Operating Humidity Range: 0 to 70% RH
 Cooling: Passive / Natural

TECHNICAL SPECIFICATIONS:

0,75A
2-20AH
2-30 AH
P.3