Technical Specifications; Charging Instructions - Fulbat FULLOAD 1000 Bedienungsanleitung

TECHNICAL SPECIFICATIONS:

CHARGING INSTRUCTIONS:

 Check the Battery Electrolyte level (Not required on sealed & Maintenance Free Batteries).
If necessary, remove the vent caps and add distilled water so the levels are halfway between the upper
and lower fill lines.
 Check the Voltage Output Switch on the charger and make sure it's on the correct voltage.
 If the Battery is out of the vehicle:
o Connect the Red lead from the charger to the positive (+) battery terminal.
o Connect the Black lead from the charger to the negative (-) battery terminal.
 If the Battery is still in the vehicle, determine if the vehicle is positively (+) or negatively (-) earthed.
o If Negatively Earthed (Most Common) – FIRST Connect the Red (+) battery charger lead to
the positive (+) Battery post and then connect the Black (-) battery charger lead to the
vehicle's chassis and away from the fuel line.
Part Number
Type
Approvals
Input Voltage Range
Input Frequency
Output
Size (L*W*H) in mm
Weight
STEP 1 - Pre Charge Check & Electrolyte Level Check
STEP 2 - Connecting the Battery charger to your Battery
FULLOAD1000
Automatic
CE, NZS, SAA
100-240V
50/60Hz
1A @ 6/12V
109*64*35
0.4Kg
UL, CUL
120V
P.4