MAINTENANCE
TABLETOP & BENCHES
° Use common kitchen cleaning products.
Avoid using aggressive products. These
surfaces are best cleaned with a neutral
cleaning product diluted in water.
° In case of stubborn stains, we
recommend using a magic sponge.
° Stubborn stains can also be removed
using acetone.
° To provide extra protection, place a dirt-
repellend film on the profiles by applying
silicone spray and carefully spreading it
with a rubbing motion.
POWDER COATED LEGS
° Clean with warm water and non-
abrasive cleaning product. Then dray
with a soft cloth.
° DO NOT USE abrasive scouring
powders or scourers as they will scratch
the surface.
MAGIC SPONGE
Only use the Miraclean sponge when
normal cleaning with lukewarm water,
soft soap and a normal sponge isn't
sufficient!
° If stubborn stains remain visible after
treatment according to the instructions
(see product manual), you can use
the MiraClean sponge provided. Dip the
sponge in water and rub it over the stain.
Do not rub too hard with this sponge as
this might cause dull patches on a
surface.
° There is no need to use cleaning
products. Water alone is sufficient.
° This sponge is made of melamine resin
and wears away with use. The sponge is
very easy to use and gives results up to
26 times more quickly than a traditional
microfibre cloth.
° The magic sponge gets rid of most
stubborn stains without extra effort.
° Never use this sponge on high-gloss
surfaces as it may cause dull patches.
° The magic sponge is the solution for
getting rid of stubborn stains such as
felt-tip pens, grease, scuff marks,
limescale marks or coffee and tea stains.
The magic sponge can be used on
tarpaulin fabric, plastic profiles, glass,
steel, chrome, aluminium, porcelain,
artificial leather and many types of floor.
° For more information, contact
Extremis: info@extremis.be
IMPORTANT
Stains should be removed immediately
with a clean, soft cloth, particularly
in case of dark-coloured liquids such
as wine, ink, coffee, coke, oil and bird
droppings. If left to dry, these liquids may
cause permanent damage!
CAUTION
We strongly advise against using power
tools given the risk of thread galling on
the stainless steel bolts.
For tables with 3 legs or move, we
recommend using trestles to attach
the table leg assemblies to the tabletop,
instead of keeping it upside down.
We strongly advise you against standing
on top of the table! A concentrated load
can cause small perceptible cracks in the
profiles that might be visually annoying,
although they do not affect the strength
of the table in any way.
english
5