Safety Instructions Relating Specifically To The Equipment; Charging Battery - MEISTER CRAFT MAS 180-22B Originalbetriebsanleitung

5451380-Akku-Bohrs-man 18.02.14 09:49 Seite 40
6 – Safety instructions
relating specifically to
the equipment
CAUTION! LED is laser class 1!
Do not look directly into the
laser as this may result in damage
to the eyes.
• Use the appliance, the charger and the
attachments, only for their intended
applications!
• Before laying the stick screwdriver
aside, ensure that all moving parts
have come to a standstill.
• Avoid frequent blocking when drilling,
tightening or loosening screws.
• Connect the charger only to a 230 V
AC power supply.
• Charge the screwdriver battery only
with the charger supplied.
• Protect the charger and the screw -
driver from contact with moisture.
Never immerse in water!
• Do not use the charger in the open air.
• To avoid damage to the batteries,
never expose them to temperatures of
over 50 °C.
CAUTION! Do not short-circuit the
contacts of the battery or charger.
• When charging, ensure that the
device is correctly connected („+/–").
• Do not attempt to burn the battery.
• The connection cord cannot be
replaced. In case of damage, dispose
40
of the device in the correct manner. In
case of damage, dispose of the
device in the correct manner.
7 – Charging battery
This battery-powered screwdriver
MAS 180-22B may only be
charged using the XR-DC240400B
mains adapter unit. The mains adapter
unit may only be operated with a
power supply that has an alternating
current of 220-240 V and a frequency
of 50 Hz. The use of any other mains
adapter units or the use of the
XR-DC240400B with another type
of power supply may lead to personal
and property damage.
The rechargeable battery is not fully
charged on leaving the factory. Charge
the rechargeable battery before first
use. Withdraw rechargeable battery (5)
from the storage battery drill
screwdriver (Fig. 2).
Fit the charger (6) to the battery
(Figure 3). Connect the power supply (7)
to a socket (230 V~) and connect
the charger plug (8) to the charger
(Figure 3).
The red control lamp will light up as
soon as contact is made to the power
supply. Put the empty battery into the
charger, make sure the polarity (+/–) is
correct. The green control lamp will light
up when electrical contact is made.
IMPORTANT! If a recently used
up battery is inserted and the
green control lamp does not light
immediately, remove the battery and
start the charging process again a
few minutes later.