Cleaning Reminder - JUNO JB136D8 Benutzerinformation

30
Stainless steel or aluminium
ovens
Clean the oven door with a damp cloth or
sponge only. Dry it with a soft cloth.
Do not use steel wool, acids or abrasive
materials as they can damage the oven
surface. Clean the oven control panel with
the same precautions.
Removing the shelf supports
To clean the oven, remove the shelf
supports.
CAUTION! Be careful when
you remove the shelf supports.
1. Pull the front of the shelf support away
from the side wall.
2. Pull the rear end of the shelf support
away from the side wall and remove it.
1
Install the removed accessories in the
opposite sequence.
Pyrolysis
CAUTION! Remove all
accessories and removable
shelf supports.
The pyrolytic cleaning
procedure cannot start:
• if you did not fully close the
oven door. In some models,
the display shows "C3"
when this error occurs.
2
CAUTION! If there are other
appliances installed in the
same cabinet, do not use them
at the same time as the
Pyrolysis function. It can cause
damage to the oven.
During the pyrolytic cleaning the door is
locked. The symbol
heat indicator come up, until the door
unlocks. The door unlocks when the
temperature inside the oven is under
safety conditions and the pyrolytic
cleaning finishes.
During the pyrolytic cleaning the lamp is
turned off.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Turn on the oven.
4. Set the Pyrolysis function. Refer to
"Oven functions".
5. Press .
6. Press or
the cleaning procedure:
Option
1
2
3
You can use the End function to delay
the start of the cleaning procedure.
7. Press to confirm.

Cleaning reminder

To remind you that the pyrolytic cleaning
is necessary, the cleaning reminder
symbol flashes in the display after each
deactivation of the appliance for the next
10 seconds.
and the bars of the
to set the duration of
Description
1:00 for a low de‐
gree of dirt
1:30 for a usual
degree of dirt
2:30 for a high
degree of dirt