Cleaning Reminder; Cleaning The Oven Door - JUNO JB136D8 Benutzerinformation

The pyrolytic cleaning
procedure cannot start:
• if you did not fully close the
oven door. In some models,
the display shows "C3"
when this error occurs.
CAUTION! If there are other
appliances installed in the
same cabinet, do not use them
at the same time as the
Pyrolysis function. It can cause
damage to the appliance.
During the pyrolytic cleaning the door is
locked. The symbol
heat indicator come up, until the door
unlocks. The door unlocks when the
temperature inside the oven is under
safety conditions and the pyrolytic
cleaning finishes.
During the pyrolytic cleaning the lamp is
deactivated.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Activate the appliance.
4. Set the Pyrolysis function. Refer to
"Oven functions".
5. Touch .
6. Touch or
the cleaning procedure:
Option
1
2
3
You can use the End function to delay
the start of the cleaning procedure.
7. Touch to activate the Pyrolysis
function.
and the bars of the
to set the duration of
Description
1:00 for a low de‐
gree of dirt
1:30 for a usual
degree of dirt
2:30 for a high
degree of dirt

Cleaning reminder

To remind you that the pyrolytic cleaning
is necessary, the cleaning reminder
symbol flashes in the display after each
deactivation of the appliance for the next
10 seconds.
The cleaning reminder goes
out:
• after the end of the pyrolytic
cleaning.
• when you deactivate it in the
basic settings. Refer to
"Using the settings menu".

Cleaning the oven door

The oven door has four glass panels. You
can remove the oven door and the internal
glass panels to clean them.
The oven door can close if you
try to remove the glass panels
before you remove the oven
door.
CAUTION! Do not use the
appliance without the glass
panels.
1. Open the door fully and hold the two
door hinges.
2. Lift and turn the levers on the two
hinges.
29