Installing Nylon Line Cutting Head; U-Handle Version - Echo SRM-265 Bedienungsanleitung

Installing nylon line cutting head

U-handle version

U-handle assembly
Before you start
1. Insert locking tool (A) into a hole located on the right side of
angle transmission while forcing retainer spring to the left
side.
2. Insert locking tool further into blade retainer fixing slot (B) to
fix output shaft.
3. Using the socket wrench, remove the nut (C), cup (D), and
lower blade retainer (E).
 Nut, cup, and lower blade retainer are not used with a nylon
line cutting head.
 Fix output shaft securely using locking tool in order to
prevent it form rotating when nylon cutting head is
mounted.
4. Thread nylon line cutting head (F) onto shaft (anticlockwise)
until it is tight.
5. Remove locking tool.
1. Install handle assembling bracket (upper) (A) in handle as-
sembling bracket (lower) (D) and fix handle by tightening
handle assembling bolt (8 mm) (B) lightly.
2. Adjust inclination of handle to adequate position (easy to op-
erate) and tighten firmly handle assembling bolt.
C: Washer
E: Arrow
F: To engine
 Install the handle so that it does not hide any of the
safety decals.
3. To eliminate loosening of throttle wire (I), fix it to shaft tube
(H) (2 places) and to right hand U-handle (1 place) with wire
fixing clips (G).
11
CAUTION
CAUTION