Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation of shield
Installing nylon line cutting head
Adjusting the balance
Adjusting the shoulder harness
This product is designed to fit a wide variety of body sizes, but may not be adjustable for extremely tall persons. Do
not use the unit if your feet can reach the cutting attachment when the unit is attached to the harness.
A person's size can affect the balancing adjustment. Also the balancing procedure may not work with some units on some
persons. If the shoulder harness does not fit you or cannot be adjusted well, please ask your dealer for assistance.
1.
Fit shield (A) to mounting portion of angle transmission and
tighten 4 bolts (B).
1.
Insert locking tool (A) into a hole located on the right side of
angle transmission while forcing retainer spring to the left
side.
2.
Insert locking tool further into blade retainer fixing slot (B) to
fix output shaft.
3.
Using the socket wrench, remove the nut (C), cup (D), and
lower blade retainer (E).
Nut, cup, and lower blade retainer are not used with a nylon
line cutting head.
Fix output shaft securely using locking tool in order to
prevent it form rotating when nylon cutting head is
mounted.
4.
Thread nylon line cutting head (F) onto shaft (anticlockwise)
until it is tight.
5.
Remove locking tool.
WARNING
IMPORTANT
11
Before you start
CAUTION
Werbung
Inhaltsverzeichnis
