KTM 660 SMC Supermoto 2003 Bedienungsanleitung Seite 21

1
3
4
LOCTITE 243
2
6
How to change the handlebar position
The handlebar position can be readjusted by 37 mm. Thus, you can put the
handlebar to the position that is the most convenient for you.
The upper triple clamp
(0,6 in) from one another. The bores at the handlebar support
from the center by 3.5 mm. Accordingly, you can mount the handlebar in
6 different positions.
For this purpose, remove screws
of the handlebar support. Position handlebar support, apply Loctite 243 and
tighten screws
clamps, and tighten screws
lebar support and handlebar clamps is to be of equal size in the front and in
the rear.
STANDARD POSITION:
The middle hole in the triple clamp and the offset in the handlebar support
facing the front.
Changing the height of the tail end
The height of the tail end can be adjusted by 48 mm to adapt the handling
to the race course. The shock absorber is fastened at the top in a eccentric
bushing.
Before changing the height of the tail end, measure the original position. To
measure, jack up the motorcycle, measure and write down the distance bet-
ween the swing arm and the end of the subframe.
"HIGH TAIL END" = better handling in curves
"LOW TAIL END"= better driving stability on straight stretches
To change the height of the tail end, loosen the clamping screws
19 mm socket wrench on the HH screw
dingly. Do not turn the eccentric more than 90 ° up or 90 ° down from the
5
standard position. The adjustment range is ± 24 mm on the rear wheel.
Tighten the clamping screws to 25 Nm.
STANDARD POSITION.
The holes in the left eccentric must
be aligned with the slot in the clam-
ping (see illustration).
5
1 includes 3 bores arranged at a distance of 15 mm
3
of the handlebar clamps and screws
4
to 40 Nm (30 ft.lb). Mount handlebar and handlebar
3
to 20 Nm (15 ft.lb). The gap between hand-
more traction on the rear wheel when accelerating
more braking stability.
6
2 are offset
4
5
. Place a
and turn the eccentric accor-
21