hanseatic WQP12-7713I Gebrauchsanleitung Seite 61

820 mm
Requirements:
– Only install the dishwasher underneath a
continuous worktop which is joined to the
units adjacent to the dishwasher.
– Maintain sufficient distance from the walls
and adjacent appliances. The measure-
ments of the recess must at least corre-
spond to the details in the diagram above.
1. Switch the fuse off.
2. Remove cardboard, polystyrene and ad-
hesive strips from the inside of the dish-
washer, if you have not already done so.
(c)
All manuals and user guides at all-guides.com
Installation, connection and initial commissioning
90°
580 mm
600 mm
3. Affix the enclosed condensation-protec-
4. Insert the two mounting brackets (f) into
90°
80 mm
100 mm
tive film (c) to the bottom of the work sur-
face. In this way, you will avoid damage
to the worktop as a result of hot steam
which may come out of the dishwasher
when the door is opened.
(f)
the front slots on the top of the dish-
washer so that you can screw the dish-
washer to the worktop subsequently.
Page EN-25