Programming More B-Tronic Transmitters In A Knx Rf Compatible Receiver From Another Manufacturer; Deleting Transmitters - Becker EC711 Montage- Und Betriebsanleitung

Programming more B-Tronic transmitters in a KNX RF
compatible receiver from another manufacturer
Please find the appropriate description in the manufacturer's instructions.

Deleting transmitters

Deleting from B-Tronic receivers with two B-Tronic
transmitters
Put a programmed transmitter, other than the one that is to be de-
leted, into master mode.
Select the device by pressing the
All the following settings will then only be executed for this device.
LED L1
Steady
light
LED L1
Flashes
0
LEDs L1
and L2 go
out
Deleting a B-Tronic transmitter from a KNX RF
compatible receiver from another manufacturer
Please find the appropriate description in the instructions for the receiver.
52 - en
button until the desired device confirms.
Then press the programming button until the re-
ceiver confirms.
Then press the programming button again until
the receiver confirms.
Now press the programming button of the trans-
mitter to be deleted until the receiver confirms.
► The transmitter is now deleted from the re-
ceiver.
Turn the function switch at the transmitter that was
used to start the operation to "0".
► LEDs L1 and L2 go out