Becker EC711 Montage- Und Betriebsanleitung Seite 51

• By switching on the voltage at the B-Tronic receiver
• With the radio switch on the B-Tronic tubular drive
• With the programming button on the B-Tronic radio receiver
3s
On the radio receiver
When the receiver is in programming mode, proceed as follows:
Briefly press the programming button on the
transmitter.
▻ The receiver confirms.
► The receiver goes into the programming
mode for 3 minutes
Switch on the power.
► The receiver goes into the programming
mode for 3 minutes
Switch the radio switch to the inside position. If
the radio switch is already in this position, switch it
to the outside and back to the inside position.
► The tubular drive goes into the programming
mode for 3 minutes
Press the programming button on the radio re-
ceiver for 3 seconds.
▻ The LED flashes green.
► The receiver goes into the programming
mode for 3 minutes
Now press the programming button of the new
transmitter.
▻ The receiver confirms.
► Programming is now complete.
51 - en