Herunterladen Inhalt Inhalt Diese Seite drucken

Nolan N43 AIR Sicherheit Und Gebrauchsanleitung Seite 20

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 22
1.5 Widen the visor and fasten the other side of the inner visor to the second pin,
see Fig. 21.
1.6 Release the visor.
1.7 Remove the second protective film from the inner visor and check that the inner
visor profile adheres to the visor.
1.8 Fix the visor onto the helmet.
CHECKING AND ADJUSTING THE INNER VISOR AIR DRAUGHT
Check for correct system fitting, by opening and closing the visor and check that
both visors are correctly fastened and do not move.
If the inner visor is not tightly fixed to the visor, move the external adjustment levers
simultaneously upwards to increase the air draught (Fig. 22). This operation must be
carried out gradually. The maximum air draught is achieved when the external levers
for the pin adjustment are turned outwards.
WARNING!!!
The presence of dust between the visors can produce scratches on both surfaces.
Scratched visors and inner visors may cause reduced visibility and must therefore be
changed.
Regularly check the correct air draught of the inner visor to prevent the same from
moving and scratching both surfaces.
If the helmet visor fogs up and/or condensation forms between the visors, check
both for system correct fitting and air draught.
An excessive and early air draught of the inner visor may result in excessive adhe-
rence against visor surface and/or permanent deformations with subsequent inabili-
ty to perform following adjustments correctly.
The extended use in special weather conditions may reduce system performance
and result in partial fogging and problems of condensation on the inner visor. In
this case, remove the inner visor from the helmet visor and dry it with dry and luke-
warm air.
2
DISASSEMBLY
2.1 Remove the visor equipped with inner visor.
2.2 Widen the visor and unhook the inner visor from the pins Fig. 21.
2.3 Release the visor.
MAINTENANCE AND CLEANING
Remove the inner visor from the visor. Using a damp and soft cloth, gently clean it
with neutral liquid soap. Remove the soap under running water.
Dry the inner visor with dry and lukewarm air without wiping it.
To keep the features of the inner visor in good conditions over time, let the helmet dry
in a ventilated and dry place with the visor open after use.
20

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis