Package Contents; Electrical Safety; Description (Fig. A); Using An Extension Cable - DeWalt D21160 Bedienungsanleitung

e Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts
and any other condition that may affect the
power tools operation. If damaged, have the
power tool repaired before use. Many accidents
are caused by poorly maintained power tools.
f Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g Use the power tool, accessories and tool bits
etc., in accordance with these instructions and
in the manner intended for the particular type of
power tool, taking into account the working
conditions and the work to be performed. Use
of the power tool for operations different from those
intended could result in a hazardous situation.
5 Service
a Have your power tool serviced by a qualified
repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
Additional safety instructions for rotary drills
• Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.

Package contents

The package contains:
1 Right angle drill
1 Chuck key
1 Key holder
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.

Description (fig. A)

Your D21160 right angle drill is a professional power
tool that has been designed especially for drilling in
confined spaces.
1 Paddle switch
2 Chuck
3 Chuck guard
4 Key holder
5 Chuck key
D21160.PM7

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D
E
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
For 115 V units with a power rating exceeding 1500 W,
we recommend to fit a plug to BS4343 standard.

Using an extension cable

If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm
When using a cable reel, always unwind the cable
completely.
Also refer to the table below.
19
Your D WALT tool is double insulated in
E
accordance with EN 60745; therefore no
earth wire is required.
WALT repair agent or a qualified electrician.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
2
.
12-09-2005, 16:45
E N G L I S H
.
19