DeWalt D26420 Bedienungsanleitung Seite 21

17 Do not abuse cord
Never carry the tool by its cord. Never pull the
cord to disconnect from the socket. Keep the
cord away from heat, oil and sharp edges.
18 Store idle tools
When not in use, tools must be stored in a dry
place and locked up securely, out of reach of
children.
19 Maintain tools with care
Keep the tools in good condition and clean for
better and safer performance. Follow the
instructions for maintenance and changing
accessories. Keep all handles and switches dry,
clean and free from oil and grease.
20 Repairs
This tool is in accordance with the relevant safety
regulations. Have your tool repaired by an
authorised D WALT repair agent. Repairs should
E
only be carried out by qualified persons using
original spare parts; otherwise this may result in
considerable danger to the user.
Additional safety instructions for sanders
Take special care when sanding some
woods (e.g. beech, oak) and metal which
may produce toxic dust. Wear a dust
mask specifically designed for protection
against toxic dust and fumes and ensure
that persons within or entering the work
area are also protected.
• Use this tool in a well-ventilated area when
sanding ferrous metals. Do not operate the tool
near flammable liquids, gases or dust. Sparks or
hot particles from sanding or arcing motor
brushes may ignite combustible materials.
Sanding paint
Observe the applicable regulations for sanding paint.
Pay special attention to the following:
1 Whenever possible, use a vacuum extractor for
dust collection.
2 Take special care when sanding paint which is
possibly lead based:
• Do not let children or pregnant women enter
the work area.
• All persons entering the work area should wear
a mask specially designed for protection
against lead paint dust and fumes.
• Do not eat, drink or smoke in the work area.
3 Dispose of dust particles and any other removal
debris safely.
Package contents
The package contains:
1 Orbital sander
1 Hook and loop sanding pad
1 Dustbag frame
1 Dustbag
3 Sheets of sanding paper
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fig. A)
Your orbital sander D26420/D26421/D26422/D26423
has been designed for quick sanding of wood, metal
and plastics in a professional environment.
1 On/off switch
2 Lock-on button
3 Speed control dial (D26420/D26422)
4 Front handle
5 Sanding sheet clamp knob
6 Sanding pad
7 Dustbag frame
8 Dustbag
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below.
E N G L I S H
21