Dust Extraction; General Safety Instructions - stayer SC241W Bedienungsanleitung

will remove the stopper so as to prevent the
workpiece as cut from wedging between the
stopper and the disk.

16.Dust extraction

IMAGE
C
All models are prepared for mounting equipment
(not included) for the aspiration of particles
generated during the cutting operation.
The extraction equipment shall be coupled to the
particle outlet nozzle 20.
Mechanical protective equipment
V X
IMAGES
1.General protective casing 1.
2.Tiltable protective hood 5.
3.Lower stationary guard 34.
4.Movable guard of the upper table 26.
Electrical protective equipment
1.Class II electrical insulation.
2.Protective module for electrical grid failures so as
to avoid fortuitous starts of a machine after
recovery after a cut off of the electrical supply.

17.General safety instructions

WARNING! When using electrical tools, the
essential safety precautions should always be
taken to reduce the risks of fire, electrical shock and
personal damages, including the following.
Read these instructions with attention before using
this product, and store them.
18.Regular cleaning,
maintenance and greasing
WARNING! .Desenchufar the plug before
performing any adjustment or maintenance
comeback.
Cleaning
Clean the machine starting with a brush or with a flat
brush so as to remove sawdust and with a soft cloth.
If compressed air is available, complete cleaning by
blowing with the compressed air pistol.
Maintenance
After each 2,000 hours of use or each two years the
electrical tool must be sent to the official technical
service for maintenance and complete revision.
All manuals and user guides at all-guides.com
ENGLISH
37
37
Before each use, check nuts and joints to detect any
vibration issues and use. If there are gaps take the
machine to service.
Except squeeze and brush change, the machine
does not require any special maintenance by the
user. Keep the machine clean and use it correctly.
Regularly have the correctness of the adjustments
checked by a sufficiently trained user. In the case of
any failure, contact our technical service.
Changing brushes
Warning!
Always use the brushes as supplied by the official
technical service.
1.Remove screw 48.
2.Remove lid 47.
3.Remove screw 50.
4.Move pressing spring 51 to the left.
5.Extract used 52 brush from the brush holder 49.
6.Insert new brush into the brush holder 49.
7.Place pressing spring 51 over the brush.
8.After applying the brush connector tighten screw
50.
9.Position lid 47.
10.Tighten screw 48.
Greasing
This machine does not require any specific
greasing by the user. Specific greasing of the
electrical tool will be carried out on the occasion of
the regular maintenance revisions at the official
technical service.
1 9 . R e p a i r s e r v i c e o f t h e
manufacturer or commercial
agent:
Stayer Ibérica S.A.
Área Empresarial de Andalucía - Sector 1.
C/ Sierra de Cazorla, 7. Postal code: 28320 Pinto
(Madrid) Spain.
20.List of parts that may be
replaced by the user
IMAGES Y Z
1.Cutting disk 21.
2.Lower stationary guard 34.
3.Movable guard 26.
4.Brushes 52.
5.Guides for adjusting the cutting depth at the lower
table 41 .
6.Guides for adjusting the cutting depth at the lower
table 27.