Care And Cleaning; Cleaning The Filter - AEG LAVATHERM 86285IC Benutzerinformation

38 www.aeg.com
–
cm
–
300-600 μS/cm
–
μS/cm
3. Push the button again and again un-
til you set necessary level (see the il-
lustration).
4. To memorise the setting push at the
same time 2 buttons as are specified
in the point 2.
8.3 Water container full —
indication
By default the indication
It comes into the view at the end of the

9. CARE AND CLEANING

9.1 Cleaning the filter

At the end of each cycle the indicator
(clean the filter) is on to tell you that the
filter must be cleaned.
low conductivity <300 μS/
moderate conductivity
high conductivity >600
is always on.
cycle or when the water container is full.
When you use an external equipment to
drain the container, the indication can
be off.
To activate or deactivate the indication:
1. Turn the programme dial to availa-
ble programme.
2.
Push at the same time 2 buttons (see
the illustration) and hold down until
you see the correct setting:
– the indication
dicator
view — the indication
manently off
– the indication
dicator
view — the indication
ted
The filter collects the fluff. The
fluff occurs while the cloths are
dried in the tumble dryer.
is off and the in-
comes into the
is per-
is on and the in-
comes into the
is activa-