Care And Cleaning; Cleaning The Filter - AEG LAVATHERM 5127AC Benutzerinformation

• Always keep the airflow slots on the
bottom of the appliance clear.
• Use the load volumes specified in the
programmes chapter.
• Make sure that is good airflow in the
appliance installation position.
• Clean the filter after each drying cycle.
• Spin good the laundry before drying.
8.2 Water hardness and
conductivity
Water hardness can be different for dif-
ferent locations. Water hardness has an
effect on the water conductivity and the
operation of the conductivity sensor in
the appliance. If you know the value of
the water conductivity you can adjust the
sensor to dry with the better results.
To change the sensor conductivity:
1. Turn the programme dial to availa-
ble programme.
2. Push at the same time the Delicate
(Behoedzaam) and Anticrease (Anti-
kreuk) buttons and hold down until
the LED above the push buttons are
on.
3. Push the Start Pause button again
and again until you set necessary
level.
– the LED Anticrease/End (Anti-
kreuk/Einde) low conductivity
<300 μS/cm

9. CARE AND CLEANING

9.1 Cleaning the filter

At the end of each cycle the filter LED is
on to tell you that the filter must be
cleaned.
All manuals and user guides at all-guides.com
– the LED Cooling (Afkoeling) mod-
erate conductivity 300-600 μS/cm
– the LED Drying (Drogen) high con-
ductivity >600 μS/cm
4. To memorise setting push at the
same time the Delicate (Behoed-
zaam) and Anticrease (Anti-kreuk)
buttons.
8.3 Water container full —
indication
By default the indication LED is always
on. It comes into the view at the end of
the cycle or when the water container is
full. When you use an external equip-
ment to drain the container, the LED can
be off.
To activate or deactivate the indication:
Turn the programme dial to availa-
1.
ble programme.
2. Push at the same time the Delicate
(Behoedzaam) and Delay Start (Star-
tuitstel) buttons and hold down until
the LED above the push buttons
flashes (3x).
– If the LED
is off - The LED is
permanently off
– If the LED
is on - The LED is
activated
The filter collects the fluff. The
fluff occurs while the cloths are
dried in the tumble dryer.
ENGLISH
67