Adjusting The Water Hardness - hanseatic WQP12-J7609D Gebrauchsanleitung

2. Loosen both screws on the reverse side
of the covering panel and remove them.
(c)
3. Affix the enclosed condensation-protec-
tive film (c) to the bottom of the work sur-
face. In this way, you will avoid damage to
the work surface as a result of hot steam
which may be emitted from the dishwash-
er if the dishwasher door is left open.
4. Place the dishwasher in the desired posi-
tion.
5. In order to equalise unevenness in the
floor and set up the dishwasher on a level
horizontal base, you can screw the four
appliance feet (26) in or out. There are
slits in the appliance feet. Insert a screw-
driver and turn the appliance foot.
Use a spirit level to set up the dishwasher.
Installation, connection and initial commissioning

Adjusting the water hardness

Hard water will cause calcification within the
dishwasher. Also, more dishwasher deter-
gent will be required to clean the dishes. Soft
water increases foaming.
For this reason, the degree of hardness of
the water has to be determined and adjusted
even before the first use. You can determine
the water hardness from your water bill or
enquire about the degree of hardness at the
water supply company. The appliance is fac-
tory-set to the "
(26)
Do not allow more than 1 minute to elapse
between the following actions, otherwise the
adjustment process will be interrupted.
1. Close the dishwasher door.
2. Switch on the appliance with the On/Off
H3
" hardness level.
Water hardness
°dH
0-5
6-11
12-17
18-22
23-34
35-55
(1)
(8)
(14) (13)
button (1).
Page EN-25
Display
H1
H2
H3
H4
H5
H6
(6)