Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Page EN-34
Installation, fitting, connection and initial commissioning
Water hardness
Determine water hardness
In order to determine the water hardness in
your place of residence, you can
– look on the website of your water provider.
– telephone your water supplier.
– purchase suitable test strips at the
pharmacy.
Water hardness in
your household in
°dH
0–5
6–11
12–17
18–22
23–34
35–55
1. Obtain the appropriate setting from the
table above.
2. Close the dishwasher door.
(1)
(8)
3. If the dishwasher is switched on, switch it
off with the button
(1).
Water hardness in
the dishwasher
H1
H2
H3
H4
H5
H6
(6)
Adjusting the water hardness
Do not allow more than 1 minute to elapse
between the following steps, otherwise the
setting process will be interrupted.
(1)
1. Close the dishwasher door.
2. Switch on the dishwasher using the
button.
3. Press and hold the P button (4) for as
long as required until the current water
hardness is shown on the display:
.
H6
4. Press the P button (4) as many times as
necessary to display the required hard-
ness level.
5. Switch the dishwasher off using the
button.
The hardness level setting is saved.
Test run
It is recommended that you carry out a test
run before the first dishwasher cycle in order
to remove residues from the manufacturing
process and in order to ensure that the appli-
ance functions perfectly.
If no water escapes during the test run and if
there are no unusual noises, the appliance is
ready to use.
Carry out this test run when the dishwasher is
empty and without any dishwasher detergent.
See chapter „Dishwasher operation" from
page EN-22 for the procedure.
(4)
(1)
to
H1
(1)
Werbung
Inhaltsverzeichnis
