Introduction; Device Description - Scheppach 5901312901 Original Bedienungsanleitung

2. Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment and
success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling
• Non-compliance of the operating instructions
• Repairs by third parties, by not authorized service
technicians
• Installation and replacement of non-original spare
parts
• Application other than specified
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regulations
and VDE regulations 0100, DIN 57113 / VDE0113
Please observe the following:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the user
to become familiar with the machine and take advan-
tage of its application possibilities in accordance with
the recommendations.
The operating instructions contain important informa-
tion on how to operate the machine safely, profession-
ally and economically, how to avoid danger, costly re-
pairs, reduce downtimes and how to increase reliability
and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in your
country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information.
32 | GB
The machine can only be operated by persons who
were instructed concerning the operation of the ma-
chine and who are informed about the associated dan-
gers. The minimum age requirement must be complied
with.
In addition to the safety instructions contained in this
operating manual and the specific regulations of your
country, the technical rules generally accepted for the
operation of machines of the same type must be ob-
served.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions and
the safety information.

3. Device description

1. Saw table
2. Saw blade guard
3. Riving knife (not shown)
4. Saw blade (not shown)
5. Table inlay
6. Table width extension
7. Locking handle
8. Scale
9. Hand wheel
10. Crank
11. Machine stand
12. On/off switch
13. Eccentric lever
14. Parallel stop with knurled nut (i)
15. Guide rail, long
15a. Guide rail, short
15b. End caps
16. Suction adapter
17. Push stick
18. Bracket for saw blade storage
19. Legs
20a. Central strut A (2x)
20b. Central strut B (2x)
21. Rubber feet (4x)
22. Stand bracket (2x)
23. Fastening points
24. Table supports
25. Table inlay countersunk head screws
26. Riving knife fixing screw
27. Screw with nut and washer
28a. Groove
28b. Groove
29. Knurled screw
30. Stop rail
31. Transverse stop with knurled nut (i)
www.scheppach.com