Technical Data; Charging Procedure - Worx WA3880 Bedienungsanleitung

TECHNICAL DATA

Rated input voltage
Output voltage
Charging current
Rated Input power
Charge battery
Number of cells
Charging time (approx.)
Battery pack
Protection class
Machine weight
For the technical data of the types, the number of cells
and the rated capacity of the batteries that can be
charged, please refer the nameplate of the battery pack
supplied by Worx.

CHARGING PROCEDURE

NOTE: Before using the tool, read the instruction
book carefully.
CHARGING INSTRUCTIONS
1. CHARGING YOUR BATTERY PACK
WARNING: The charger and battery pack are
specifically designed to work together so do
not attempt to use any other devices. Never insert or
allow metallic objects into your charger or battery pack
connections because an electrical failure and hazard will
occur.
2. BEFORE USING YOUR CORDLESS TOOL
Your battery pack is UNCHARGED and you must charge
once before use.
3. HOW TO CHARGE YOUR BATTERY
Battery Charger
100-240V~50/60Hz
20V
50W
Li-Ion
4/5/10
-- 1.3Ah 42mins
-- 1.5Ah 45mins
-- 2.0Ah 58mins
-- 2.5Ah 77mins
-- 3.0Ah 95mins
-- 4.0Ah 125mins
-- 5.0Ah 145mins
-- 6.0Ah 183mins
0.45kg
CHARGING PROCEDURE
1) Plug the charger into an appropriate outlet.
2) Slide the battery pack into the charger. The LIGHT (3)
will become green and flash to show charging has
started.
3) After charging approx 1-2 hours, the light will stay
green without flashing, which means the battery is
full, and charging is completed.
2A
WARNING: When battery charge runs out
after continuous use or exposure to direct
sunlight or heat, allow time for the battery to cool
down before re-charging to achieve the full charge.
CHARGING INDICATOR
This charger is designed to detect some problems that
can arise with battery packs. Indicator lights indicate
problems (see table below). If this occurs, insert a new
battery pack to determine if the charger is OK. If the
new battery charges correctly, then the original pack is
defective and should be returned to a service center or
recycling service center. If the new battery pack displays
the same problem as the original Battery Pack, have the
charger tested at an authorized service center.
Light ON/ Flash
Red on
Red flash
/II
Green on
Green flash
- - - - - -
BATTERY TEMPERATURE PROTECTION
This charger has a battery temperature protection
feature. When the charger detects a battery pack
that is too hot or cold (the light will be red and flash),
it automatically activates the protection circuit, and
suspends charging until the battery pack has reached
the correct temperature. The charging process will then
automatically begin (the light will be green and flash).
This feature ensures maximum battery life.
LEAVING THE BATTERY PACK IN THE CHARGER
If a fully charged battery pack is left in the charger, the
Light will remain green. The battery pack will remain
charging with a maintenance trickle current.
Status
Defective Battery
Battery Temperature
Protection
- - - - - The temperature of bat-
tery pack is less than 0
or more than 45
Fully Charged
Charging
5
C
o
C.
o
EN