Rupes LK900E Original Bedienungsanleitung Seite 6

PICTOGRAPh
TEChNICAL SPECIFICATIONS
TYPE
Ø POLISHING FOAM mm
Ø BACKING PAD mm
Ø ORBIT mm
POWER
R.P .M.
WEIGHT according to EPTA-Procedure 01/2003
ELECTRONIC SPEED CONTROL
INSULATION CLASS
The values shown are based on a nominal voltage of 230V/50Hz. In the case of voltages and frequencies of different power values may vary. Refer to the label technical
specifications to the nominal values of the tool.
WARNINGS
The safety and accident prevention instructions are reported
in the "SAFETY INSTRUCTION" booklet which is an integral
part of these documents. This operating instructions manual
indicates the additional information required for the specific
use of the tool.
CORRECT USAGE
This tool is designed to be used as a polisher. Read all the
warnings, instructions, indications provided on drawings
and specifications supplied with this tool. Failure to comply
with all the instructions provided below may cause electrical
shocks, fire and/or serious injuries.
This tool is not intended to be used for smoothing, metal
brushing and cutting operations. The use of this tool for
unintended applications may cause hazards and injuries to
people.
The tool must be used with accessories that have been
specifically designed or recommended by the manufacturer.
The fixing of the accessory to the tool does not guarantee a
safe operation.
The rated speed of the accessories must be at least
equivalent to the maximum speed specified on the tool.
Using the accessories at speeds above the rated one, may
cause them to break or be projected into the air.
The external diameter and thickness of the accessories
must match the specifications of the tool. Accessories
with incorrect dimensions cannot be adequately protected or
controlled.
The configuration of accessories must match the tool.
The use of accessories that cannot be perfectly fitted on the
Warning symbol/ Warning message
Read instruction manual
Wear eye protection
Wear ear protection
Wear a mask
Wear a gloves
CE compliant
EurAsian Mark
Italian Quality Mark
C-Tick Mark
Disposal of decommissioned
Arrow Act in the direction indicated by the arrow direction
tool may result in imbalance, excessive vibrations and in the
impossibility of controlling the tool.
Do not use damaged accessories. Before use, inspect all
the accessories. Inspect the supporting pads and verify
there are no cracks, tears or excessive wear. If the tool or
accessory has fallen, verify that it is not damaged or install
a new accessory. After inspecting or installing an accessory,
test the operation of the tool at maximum speed and without
load for one minute, keeping at a safety distance. If the
accessories are damaged, they will break during this test.
STARTING UP
Voltage and power frequency must match the data
displayed on the identification plate (1). Make sure that
tool is switched off before plug is connected.
TOOL ASSEMBLY
Position the cap (7) on the gearbox such that the holes for
mounting the screws (5) are aligned with those on the gearbox.
ASSEMBLY OF ACCESSORIES
PLATE BASE (Fig. a, Fig. b)
- Align the 6 holes of the gasket (9) to the plate base (8)
- Place the plate base (8) by aligning the 6 holes with the
aluminium support
- Fix the plate base (8) using the screws (12) taking care to
place the fixing washers (11) (10) correctly.
ATTENTION: do not tighten the screws of the plate base
if the latter is in not properly placed
POLISHING FOAM
Apply pressure on polishing pad to join pad to plate (8).
ENGLISH
ISO7010 - W001
ISO7010 - M002
ISO7010 - M004
ISO7010 - M003
ISO7010 - M016
ISO7010 - M009
LK900E
165
150
5
900
250 ÷ 560
3,00
•
/ II
6