General Safety Instructions - MTD Cub Cadet Zero Turn 17AIEACI603 Originalbetriebsanleitung

EN
Before carrying out any work on the mower
Protect yourself against injury by doing the
following prior to all performing work on the
device:
-
- Remove the ignition key
- Engage the parking brake
- Wait until all rotating parts have come to a stand-
still
- Wait until the engine has cooled down
-
that the engine cannot inadvertently start.

General safety instructions

Never let the engine run when in buildings or
poorly ventilated spaces. Risk of fatality due to
carbon monoxide poisoning!
Spare parts and accessories must satisfy the
requirements speci ed by the manufacturer.
You should therefore only use original spare
parts/accessories, or those which have been
approved by the manufacturer. Always observe
the installation instructions supplied with the parts
during replacement. The use of spare parts or
accessories not approved by the manufacturer
Have repairs performed exclusively by a
quali ed technician or service centre.
Do not carry passengers on the device. The
mower is not licensed for transporting people.
This device is designed for looking after
grass and lawns in a domestic environment.
Due to dangers posed to the body of the user or
other persons, the device must not be used for
purposes other than those intended.
Operate the unit in daylight or adequate
arti cial lighting only. Keep your work area
clean and well illuminated.
Escaping hydraulic uids or other such
pressurised liquids can cause severe injuries.
Never attempt to feel leaks with your hand!
Use a piece of paper or cardboard to do this.
Wear gloves and some protective goggles when
checking for leaks. If liquid gets into the eyes,
seek immediate medical attention. Never carry
out checks, if pressurised systems/lines remain
under pressure. Only allow service centres to
work on pressurised systems or lines.
12
Safety information
Regularly ensure that the cutting blades
come to a standstill about ve seconds after
the cutter deck is switched o (this can be
detected audibly because rotating cutting
blades produce a wind noise). If the cutting
blades do not stop within this time frame, the
device should be checked by a service centre.
Ensure maintenance work is always
performed to schedule so that the mower
remains in a safe condition.
maintenance may lead to device damage and
thus to injury.
The engine and exhaust become hot and can
lead to buns. Do not touch!
Only use the mower in dry weather
conditions. Keep the mower away from rain or
dampness. If used on wet grass, the mower may
slip because of reduced adhesion.
Do not use the mower if it is raining or there
is a risk of storms.
Handle fuel with care. Fuel and petrol
vapour is explosive and petrol is extremely
ammable.
engine is running or still hot. Only refuel the
mower outside. Store fuel in approved containers
only and never close to sources of heat (e.g.
heaters, stoves or hot-water boilers). Have a
damaged exhaust unit, fuel tank or fuel cap
replaced.
Do not start the engine if any petrol has been
spilt. Push the mower away from the area where
the petrol was spilt and wait until the petrol fumes
have evaporated.
To prevent a re hazard, keep the engine,
exhaust, battery, the fuel tank and the
hydraulic parts free from grass and leaking
oil.
Also follow the instructions in the engine
handbook.
Safety information