Troubleshooting - Scheppach TS310 Original Bedienungsanleitung

14. Troubleshooting

Problem Possible Cause
Saw blade gets loose Fastening nut tightened insufficiently
after turning off the motor
Motor does not start Fastening nut tightened insufficiently
Extension cable defect
Connections on the motor or switch defect
Motor has wrong direc- Defective capacitor
tion of rotation Wrong connected
Engine does not provide Cross-section of the extension line is not
power,the fuse triggers sufficient
Overload by blunt saw blade
Burns on the cutting Wrong saw blade
surface with longitudinal Longitudinal stop not parallel
cuts with cross cuts
Slide carriage not parallel
32 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Help
Tighten fastening nut, right-handed thread
Check the mains fuse.
See "Electrical Connection" in the operating
manual
Have it checked by an electrician
Check by qualified electrician
Exchange the polarity of the wall socket by
qualified electrician
see Electrical connection
Change saw blade
Insert a sharpened saw blade
Insert saw blade with 20 or 28 teeth for longi-
tudinal cuts
Exchange the longitudinal stop